Sink faucet maintenance should keep these five points in mind to take precautions

The faucet is the most frequently used type in the hardware bathroom. It can’t be separated from the daily washing and kitchen cleaning, so the frequency of replacement is shorter than we expected. How to do daily cleaning and maintenance is a key to extending the life of the faucet.

Nowadays, there are many kinds of products on the market, and there will be some omissions in some time. VIGA today introduces you to the fact that if your faucet has too much lead content, how to clean and reduce the harm of lead. Whether there is an accident or not, it is always good to strengthen the cleaning and maintenance of this link to prevent.

1.There is a knowledge to take water from facuet to ensure the health drink water
Experts suggest that when you turn on the faucet every morning, you can first put the water out of the faucet first, and put the water in the bucket, which can be used to rinse the bathroom, mopping the floor and so on. Because the water when the faucet is just opened often carries more harmful substances, such as more lead. In the same way, the faucet that has not been opened for a long time cannot be used for drinking immediately.

2.The longer the sink faucet is, the more lead is distributed, so the faucet needs to be replaced regularly.
You should change the sink faucet regularly. Chlorine is now used as a disinfectant in water, and residual chlorine compounds in the water can exacerbate the precipitation of lead in the sink faucet. In general, H59 brass faucets have been used for more than 5 years, and lead precipitation has increased significantly. Therefore, it is recommended that the faucets in the residents’ homes should not be used for too long.

3.Diligently clean and remove aerator impurities
If it is used for a period of time, it is found that the amount of water is reduced, and even the phenomenon that the water heater is turned off may be caused by water and sand blockage in the aerator. At this time, gently unscrew the aerator at the spout of the faucet to remove impurities. In general, the impurities of the aerator are cleaned regularly for up to three months, and good water quality is better for the health of the family.

4.Cleaning faucet surface
To protect the faucet clad layer, use a wrung soft cotton cloth to clean it. Do not wipe it directly with a wet towel to avoid scaling. Do not wipe the faucet with the material with the burr. This will damage the clad layer. Avoid not letting the faucet touch the acid-base liquid. Spray a neutral detergent onto the soft cloth and gently wipe the faucet.

5.To prevent plating aging using albumen
Sometimes the aging of the clad layer leads to tarnish, and the albumen can keep the gloss of the clad layer. The albumen is beaten to a slightly foaming state with an egg beater, then the faucet is cleaned with warm water, dried, and then use a soft cotton cloth to rub a little albumen and gently wipe the tarnished part to protect the gloss of the clad layer.